Disclaimer: This is a user generated content submitted by a member of the WriteUpCafe Community. The views and writings here reflect that of the author and not of WriteUpCafe. If you have any complaints regarding this post kindly report it to us.
It is a great way to configure and reset your Epson printer and fix any lingering issues. This article will guide you through each step.
Resetting the Epson Printer
- Turn off the printer
- Press the reset button on the printer's back with a paperclip or tip of a pen.
- Hold the reset button while turning on the printer. Continue holding the reset button.
- After five seconds, a warning message will be printed. Press the reset button.
- Another sheet showing the factory reset IP address will be printed after about five seconds. The default address for newer Epson models is a DHCP.
Also read:: How to troubleshoot Epson printer
Configuring the Printer
-
- Open Safari on an iPad or other connected device to the Revel network.
- Tap Go and enter the IP address of your printer.
- Next, you will be directed to the login page. The following information is required:
- Username: Epson
- Password: *Your printer's serial number
- If the serial number is not working, you can try again using the username “Epson”, and the password “Epson”.
- The Configuration Navigate to the menu TCP/IP.
- The following settings can be set up on the TCP/IP settings page
Also read:: Epson Printer Customer Service
Configuration Your Epson Printer
-
- Get your IP address: Manual
- Automatic Private IP Addressing is used (APIPA)Disable
- Use PING to set: Disable
- IP: The printer's IP address (Revel's standard address range is 192.168.22.205 to 192.168.22.219)
- Subnet Mask255.255.255.0
- Default Gateway0.0.0.0
- Socket Timeout Valuable:300
- Tap Submit.
- Power cycle or reset the printer.
Legacy Epson Configuration
You will need to temporarily alter your iPad IP address if your Epson printer has a default address of 192.168.192.168.
- Navigate to the iPad Settings > Wi-Fi
- Tap the blueiTo the right is the connected network
- Tap manual to the right Configure IP:
- Tap on the IP address to change it to 192.168.192.100. However, any a number within the range 192.168.192.xxx will work.
- Tap Save In the upper right corner.
- Your iPad can now communicate with addresses within the 192.168.192.xxx area.
- Proceed to the configuring the printer section to complete printer configuration.
