What is flashing in roofing? It is used in various exterior areas of a house, including walls, doors, windows, roof valleys, and porches. This material is used to keep a house’s roof watertight, otherwise rainwater would run off the upper roof tiles and disappear into the house’s interior. If flashings weren’t used, water would trickle down between roof tiles and run off the roof surface, which could cause problems later.
Base flashing
In the process of erecting a new roof, it is important to adhere the base flashing to the membrane as firmly and as securely as possible. Flashing material must be durable, reinforced and impermeable to moisture. It should also be compatible with adjacent roofing materials. The materials used for base flashing must meet the specific requirements of the membrane manufacturers. The proper choice of material for the base flashing of a roofing system will make the roof look more appealing.
Step flashing
In roofing, step flashing is one of the most critical parts of a roof. Installed properly, it prevents leaks in the transition points between sections of the roof. When properly installed, this step flashing provides a water-tight seal. In fact, many roof leaks originate in this area. However, if installed incorrectly, step flashing can lead to serious problems such as rotting plywood or sheetrock.
Counter flashing
Counter flashing is an important part of your roof and chimney. This type of flashing directs water away from the roof and chimney. During the process of laying brick or mortar, the counter flashing must be installed, so some workers skip this step. The roofer must also cut the ridge and seal it before installing the counter flashing. However, over time, the sealant may wear out and this requires you to replace it. Make sure the counter flashing extends far enough up the wall to avoid water seeping into the attic.
Sill flashing
While roofers often rely on rubberized asphalt membrane as a roofing material, flashing tape can also be used as a roofing material. Often, the tape is sold in rolls four to six inches wide, which are then cut to fit inside the rough opening. This material prevents water from penetrating the opening. Molded vinyl flashing is also sometimes referred to as a sill pan, and it is preformed to fit inside the rough opening and features a slope to drain water. Sill pans are used for windows with vinyl cladding, while they aren’t as common on wooden windows.
Drip edging
Drip edging in roofing is a vital part of your roof. It is made of strips of metal that are nailed or overlapped around the edge of your roof. Drip edges prevent water from infiltrating underneath your shingles and causing problems. According to Chase Roofing LLC, installing drip edging is required by most building codes. Drip edges are usually L-shaped to keep water from seeping under the shingles and damaging your house.
0