If you're not sure how to set up an above-ground swim pool, you may be wondering how to prepare the site for it. First, you need to make sure that the ground is level. In some cases, you'll need a Bobcat to get the job done. Then, you'll need to assemble the above-ground pool and add the top rail and decorative caps. For the base, you'll want to place stone dust around the perimeter.
Next, you will need to place bottom rails and posts. After that, you can put in the rails. If you don't have them, you can use posts to secure them to the wall. Be sure to use rails that are at least 8 feet from the ground to create a smooth surface around the pool. Afterward, you'll need to place the top caps and top rails.
Next, you'll need to level the ground. A concrete trowel or long straight board will do the job. It's important to use a flat surface to avoid damaging the surface. If you can't find a level, you can purchase a transit and install it. Lastly, you'll need to install stabilizer rails. These are the last steps in setting up an above-ground swim pool.
The final step in setting up an above-ground swim pool is to add the top rails. Then, you can add the bottom rails. The bottom rails will support the weight of the water. You'll need to add the bottom rails to the sides of the pool. Then, you need to place a cove around the pool. This will provide a protective layer between the metal frame and the liner. You can also install a wall acquainting the two ends.
Once you've determined the center point of your above-ground swim pool, you'll need to level the entire area. This will require you to lay down bricks evenly around the pool area. Then, you'll need to install the return wall fitting. Once you've finished laying the floor of your pool, you'll need to install the return-wall fitting. The return wall fitting is located through the hole in the liner.
Once you've chosen the location for your above-ground swim pool, you'll need to install the pool walls. After you've placed the walls, it's time to assemble the above-ground wall. Afterwards, you'll need to add the cover. Once you've done this, you can move the pool wall around the pool. When the pool is completed, the wall will be bolted into place.
