1. Business

Metal Corner Brackets

Disclaimer: This is a user generated content submitted by a member of the WriteUpCafe Community. The views and writings here reflect that of the author and not of WriteUpCafe. If you have any complaints regarding this post kindly report it to us.

Super heavy-duty bracket we're going to use Metal Corner Brackets in 2-inch by 360 angle iron and also 2 inch by half inch flat bar plate will show you how it all goes together let's get started alright so we get started here cut the two inch angle and we're using the fine 14 inch longer metal cut off saw this thing is amazing it cuts through this stuff with ease now we've got 18 are we've got eight brackets each bracket is taking two pieces of angle iron so they're 16 pieces and each piece has cut a 45 on each end and a straight cut on the other and you can see how we're cutting 45 right here and then we go to the straight pieces right there and it certainly didn't take very long.

This thing really is amazing it really cuts through this metal light like butter and there's all the pieces all cut and once that too in Chiang line pieces were cut I went right to the half inch plate now I tried to cut the half inch plate with cut-offs all work fine but i thought that this would be a much faster way to go this is the everlast power plasmas 60s that i have here and you can see that this is half inch plate and it cuts the stuff pretty easily I've cut up to one inch plate without too much problem at all and you can see that I've got a straight piece of flat bar stock i'm using for a straight edge right here.

I just run the side of the plasma cutter along that straight edge and that cuts a pretty straight cut this is real-time right here so you can see the actual cut itself you know it gets pretty clean but when it goes through it leaves the dross on the other side which is easily chipped off and you'll see that here in a little bit and here we are cutting all the pieces again 16 pieces we need for the angles and there you see you just a couple of hits with the children and you can see how clean those cuts are worked out pretty good now these are the seven half-inch pieces we need for the upper brackets and again clouds will put a plasma cutter right through.

There pretty good and then just cleaning Metal Corner Brackets him up with ease and after we got all those pieces cut I just done i took him over to the belt sander and I didn't really need to do this they were so clean but i just wanted to take the sharp edges off all the pieces and i gotta say that down that worked out really good ok well there it is very powerful little while cutting with the mellow out saw and clouds because what we hear we were able to get all the pieces cut and now we got some drawing to do quite a bit of your own we're going to be able to use the drill press and Matt grill.

Login

Welcome to WriteUpCafe Community

Join our community to engage with fellow bloggers and increase the visibility of your blog.
Join WriteUpCafe