These are small panels and there's a small bit of warpage in this but that's because it's such a small panel but there's a lot more warpage than this if you look at it and what's on the other one see how bad that one is compared to this one here well I got this piece of 14 gauge here now what I'm going to do is I'm going to run a bead Metal Corner Brackets of each type of wire on here so we can compare them later on and see what the differences are in this is the o23 wire so there you have the o23 wire now I'm going to go up and I'm going to step up and go up to the o3 wire which is uh as this is for gas as well and we're going to go through the same process again I'm going to change the machine over for this wire here and we're going to try this the same process same techniques and see what it looks like okay so I took the large roll of o23 off which is six millimetres. Large metal corner brackets, Metal corner brackets for wood, Heavy-duty metal corner brackets, Long metal corner brackets, Metal corner brackets Screwfix, Decorative metal corner brackets, Corner brace brackets, L brackets.
Outdoor screws Screwfix, Railway sleeper brackets, Screwfix railway sleeper brackets, Railway sleeper brackets b&q. And I got to put on the larger roll or the small roll of o2 o30 sorry get that straight away now the problem you got is this here this is a small roll so it takes a small section on it this here has an adapter on it for taking a larger role so I'm going to remove this adapter in order to change it over to the small wheel now the larger wheels are just held on with like an outfit like that sometimes there's a pin in them so you just remove all that you don't really have to remove all that then you just take off this in over here pull all that off and hold on to the Outdoor Screws washer you slide that on and you put the spring and the washer and everything back on again like.
So now I got the wire in place before I run it though I got a change over the wheel on it because this is set up for o23 wire you can see it's a smaller wheel on it and the setup for that there so I had to turn it around and reinstall it so the wheel would be on the larger side now that's ready for the uh larger wire I'll just feed the wire through it, okay the other thing you got to do is change out the tape this is the o23 tip here I gotta take that out and I got to put in an o3o tip so I got that changed over with the new wiring out I got the nozzle on and start welding okay I played around with the welder playing around the settings on the weather because it's different wire size until I got to a heat range setting or basically that I was laying down a nice pass right and now this one's different now because I had to lower my wire speed down to about uh 45.
