If you see an error code on vacuum that means there is some issue that needs to be resolved immediately. Shark error 9 appears when your vacuum bumper has some hardware problem.
This issue can prevent free movement of your vacuum. Below, we have listed different solutions that can help you fix Shark vacuum error 9.
1) Tap on the bumper
Debris or dirt accumulated on the bumper can cause this problem. To fix this problem, tap on it at least 10 times to remove the debris that is interfering with the functioning of your bumper. Turn t upside down and jiggle it a few times.
2) Power cycle your bumper
Performing a power cycle can help you get your vacuum to the normal functioning state. Below are the steps that you need to follow to power cycle your Shark vacuum.
- Flip over your Shark vacuum
Press the power switch for a few seconds. - Now, your vacuum will turn off. Wait for at least 1 minute.
- Charge your vacuum by connecting it to the charging base.
- Disconnect it from the charging base and then test your vacuum.
3) Clean the trash bin
Another way to fix Shark vacuum error 9 is to clean it by following the steps mentioned below.
- Don't take any action until your robot is in the charging station.
- Press the button of Clean. When you do so, al the dirt and dust collected will be transferred to the bin.
- Now, empty the trash can by throwing all the garbage..
- After that, install the dust bin again and then your vacuum will continue with the cleaning process again.
