While many homeowners don't have basements, they still need a sump pump installation for the protection of their homes. In addition to providing a dry, clean storage area, sump pumps can also increase the value of your home. Before getting started, though, you should know the different types of sump pumps. This way, you can choose the right one to protect your property from water damage. Here are some tips to keep in mind when installing a sump pump:
Install the PVC pipe by inserting it through a joist or a wall near a vertical riser coming from the pump. Use a 90-degree elbow fitting and mark it against the two pipes. Next, insert the pump into the pit by turning the float on the base. Check for plumbness. After the pipe is installed, lower the pump into the pit. Make sure to close all the valves and shut off electricity before removing the pump.
When installing a new sump pump, make sure to level the pit first. Use a pointed trowel to make sure the pump is level. Be sure to install a float switch as well. You can also install a check valve to direct water away from the sump. Lastly, you must connect the discharge hose to the exterior of your home. For the discharge hose, use PVC pipe with glued elbows.
If you have a basement, the first step in the installation process is to remove any plants that are growing on the ground. A sump pump installation crew can remove sections of the lawn and clean the basement floor before installing the pump. They will also check the discharge line to ensure that the discharge location is safe for use by lawn mowers and tractors. Then, the entire sump pump installation crew can clean the area of the basement floor.
A backup battery pump is another important feature to choose. It will allow you to use the pump during flooding, while also reducing the strain on your primary pump. It can also give you more time to bail out an overflowing sump pit. Battery backups are recommended for your sump pump, as they will save you time and money if the main unit is offline. Finally, always remember that a backup sump pump is important to protect your home.
Before attempting to install your sump pump, you should lay down a layer of gravel in the bottom of the pit. This layer will keep silt from clogging the pump's motor. You can also use a stone paver to provide a firm base for the pump. These steps can be done by a qualified professional Plumbers In Georgetown KY. If you're unsure about whether or not you're ready to install your new sump pump, be sure to read the instructions carefully.
If you're planning to install a new sump pump, it's best to check the manufacturer's user manual first. It should show you how to install the unit, as well as the parts it uses and what accessories it comes with. Before tackling the actual installation, make sure to disconnect the power supply and check valve. Once you've completed all this, remove the old pump and remove any debris that's visible.
0
