The LCD flex and antenna ribbon and then you can remove the daughterboard now disconnect antenna ribbon from topside then unscrew this one which is holding them at the board down and then we'll go ahead and remove the motherboard. Now we'll remove our piece vibrator and antenna cable then we'll go ahead with Samsung phone parts and remove the battery in order to remove the battery we'll have to heat up the other side on the screen I give you a tip here if your screen is okay and you want to remove the battery you don't want to keep your hot air temperature too high and burn the screen. Then we'll use battery remover and pull the battery from one side and the battery is out here is the replacement part now we are going to assemble it with all those components we have removed from so let's go ahead and finish the rest of the the work first.
The Mobile Parts and Devices:
Put the earpiece in its place then vibrator then motherboard and tight the screw to hold the motherboard down then place the daughter board and connect display flex to it then connect the antenna cable on both sides. Now Samsung phone parts place a thumbprint scanner plug it in. Then the screw it down then use double-sided tape and stick the battery now connect both boards using man flex cable once we make sure everything is plugged and connected properly we'll go ahead and clip the component cover and screw it down this is the point you can test your phone and make sure everything is working as it should be after tightening the screws we'll stick the back cover and turn the phone on to make sure screen is working fine this will take a little.
