There is a wide application of disposable gloves both in industrial and health centres. Their use helps in cross-contamination reduction, reducing the infection risks, and maintaining appropriate hygiene levels in the workplaces. This can basically be attained by being knowledgeable on the proper ways of wearing the said gloves. The knowledge helps in lowering the tearing risks of gloves plus undoing protection offered by them. This article presents the breakdown of the way of putting on disposable gloves. The aspect would make you informed on how to safely go about a given task plus with minimal risk. So, the step-by-step process discussed here would lower incidence occurrence in the workplaces.

Step 1 – figure out the Size of the glove

It is crucial to first make sure that the gloves that you intend to put on are of the right size. Such size means that they are not too tight to rip. They should also not be too loose to an extent of reducing dexterity or falling off. 

Step 2 – take off All Jewellery

Catches on bracelets or large stones on rings are capable of snagging disposable gloves, which may make them break or tear. It is therefore wise to remove them before you pull on your gloves.

Step 3 – make sure your Hands Are Clean 

Although gloves play a central role in protection, it would also be wise t make sure your hands are clean. This helps in making sure that in case of rip or tear occurrence the underneath skin would still remain clean thus lowering the spread of infections. The hand should be washed with either antibacterial hand gel or soap with water. Make sure the hands would be dry prior to putting on the gloves.

Step 4 – get the Gloves out of Their Packaging 

While getting them out, one should make sure the gloves have no signs of rips or tears. This makes sure they are in good order before wearing them.

Step 5 – first put on Your Dominant Hand 

It is recommended to put it on to first cover your dominant hand while using the other hand in picking up the glove by cuffs inside. This should be followed by simply sliding the said hand into the glove. 

Step 6 – wear the glove on the Other hand

Again, push the hand into the opening of the glove while holding its cuff. Make sure your fingers will not be too flexed while moving your hand inside until they reach their designated holes.

Step 7 – fix The Gloves

If necessary adjust the gloves so that they can cover the entire hand and fit properly around the fingers. While doing so, make sure they will not be pulling too much with an aim of preventing tears and rips. It would as well prevent touching your wrist skin when adjusting the cuff glove.