The CJT Concealed Joist Tie is part of our concealed structural connector range, which combines structural strength with invisibility. The CJT offers tested performance in a joist connection with a clean, concealed look. Designed for versatility as well as hidden beauty, the CJT allows the joist to be angled up to 45° up or down with no reduction in load. It is part of a concealed connector system that includes the CBT and CPT.Get more news about cjt connector,you can vist our website!
Features & Benefits Manufactured in heavier gauge steel for a stronger connection Can be installed three ways: with no routing of the header/post or beam (for a quicker installation) or with the header/post or beam routed for a flush look Joists can be sloped up to 45° angle with full table loads This connector can be used for end of header joists or corner connections Tested and load-rated engineering data available Suitable for Glulam and solid sawn timber All pins and fasteners needed for installation are included Installation Use all specified fasteners The CJT Kit comes complete with 70mm dowels and Simpson Strong‑Tie® Strong‑Drive® 6.4mm x 76mm Heavy‑Duty Connector screws. Screws require a hex‑head driver Router end of beam for screw heads for flush installation The carried member may be sloped up or down to 45° with full table loads To provide maximum beam width for use with short dowels, centre in beam Note: This connector requires special attention to ensure correct installation. The beam must be installed perpendicular to the support member. The connection's components may be damaged if the beam is rotated from its opposite end during or after installation. Damaged components may not be noticeable and may reduce the connector's load carrying capacity
