So this is what I want to do with the fishing hook just want to embed them in a piece of duct tape not only to help keep them nice without rust and whatever but also to so that they don't fall out and fall out all Dynamo Walking Cane over the place and it does help you keep you safe from getting stabbed so that will go inside and then I have some band-aids here that will also go inside the stave and I'm gonna get some fishing line off of here probably about thirty feet or so that ought to go in there just fine as well what I've decided to do is to make sure that these are nice and sealed up with a coat of clear they just rust-oleum clear gloss and that's just to make sure that nothing happens to this wood when I put the tape on there it's all gonna be sealed up anyway but I just it's part of my OCD I guess yeah.
We'll just let that dry stick the parts in there and then seal it up with the packers tape all right now that the paint is thoroughly dried a nice fresh piece of tape in there and I'm just gonna make sure that the backside is sealed up nice all right that's nice and sealed so now I can start stuffing all of the ingredients in here all right I trimmed these fishing hooks so two can fit in here I'm gonna stick them up at the top really tight fit it looks like I might be able to fit at least four band-aids in here but if I get four band-aids in that I'm not going to be able to get the fishing line in and what I might have to do with the Walking Cane is just wrap it around the pole which that might not be a bad idea that way I can get more band-aids in and it'll keep the fishing line from getting too mangled up inside there you all right now that everything is sealed up inside.
And the fishing line is on well I get my brother guess he doesn't want to text me back so he gets whatever color that I want for him he said something visible but then he says hey I might change my mind so well I guess he's gonna get some 550 cord this is green all right so that's a small hole and let's see if I got it small enough to go through yes I did folks through the other side now just like I had planned tie a very very short and did not write at the end of that weld and that'll just pop right into place there and you can hardly even see it because I've countersunk this hole and now I got to do just wrap it about 30 feet should come on about down to here you I ended up just drilling another hole at the very end and just popping it in through there and that way this whole thing just stays really really monster tight when I when I tighten it up rather than just having a loose knot down here that can just you know rotate and slide around this pole and get loose over time I decided just to terminate it this way opposite direction of this way so so this this knot is on that side and this knot is on the other looks pretty good though.
